MAT'L od3.25 id.578 zlim-1 zface.02 zclamp2.375 type4=ALUMINUM_ 3.10 TOOL 1 in/out2 *** ANGLED FACE AND FINISH OD_ 3.10 $ TYPE 1 mat1=TIN tnr.015 size.5_ 3.10 POINT x3.3 z-.32_ 3.10 COMP ang0 lft/rt1 f6_ 3.10 POINT x3.2425 z-.3125_ 3.10 LINE angle0_ 3.10 RADIUS .005 type0 (xc3.2325 zc-.01030271)_ 3.10 LINE angle271_ 3.10 POINT x2.625 z0_ 3.10 LINE angle270_ 3.10 POINT x1.1 z0_ 3.10 UNCOMP angle270_ 3.10 TOOL 2 in/out1 *** CARBIDE INSERT DRILL_ 3.10 $ TYPE 17 mat0=TIN tnr0 size1.25_ 3.10 DRILL g74 rap.1 cut-2.2 peck3 tip180 ret.1 f.003_ 3.10 TOOL 3 in/out1 *** ROUGH ID_ 3.10 $ TYPE 1 mat1=TIN tnr.032 size.375_ 3.10 ROUGH xstk.01 zstk.003 depth.1 x1.2 z.05 safang90 f4_ 3.10 COMP ang270 lft/rt1 f6_ 3.10 POINT x2.4 z0_ 3.10 LINE angle270_ 3.10 RADIUS .0175 type2 x2.28125 z0 (xc2.31625 zc-.0175)_ 3.10 LINE angle180_ 3.10 POINT x2.28125 z-.0625_ 3.10 LINE angle240_ 3.10 RADIUS .001 type0 (xc1.8145 zc-.1983938)_ 3.10 LINE angle180_ 3.10 RADIUS -.0625 type2 x1.8125 z-.40625 (xc1.6875 zc-.34375)_ 3.10 LINE angle270_ 3.10 POINT x1.375 z-.40625_ 3.10 LINE angle180_ 3.10 !RADIUS -.0625 type2 x1.375 z-2.25 (xc1.25 zc-2.1875)_ 3.10 "LINE angle270_ 3.10 #POINT x1.2 z-2.25_ 3.10 $UNCOMP angle270_ 3.10 % unROUGH _ 3.10 &POINT x1.2 z.2 f0_ 3.10 ' TOOL 1 in/out1 *** FINISH ID_ 3.10 ($ TYPE 4 mat1=TIN tnr.015 size.375_ 3.10 )POINT x.5 z.2_ 3.10 *FACE x.5 z-2.2 xcut1.25 zcut-2.247 depth0 f5_ 3.10 +POINT x.5 z.2 f0_ 3.10 ,REPEAT from20 thru24_ 3.10 -POINT x.5 z-2.25_ 3.10 .UNCOMP angle270_ 3.10 /POINT x.5 z.2 f0_ 3.10